Filter
Top Products
( 22 / 84 )
* Please keep the M3062NT3-RPD-E's packing box and cushion material in your place for reuse
at a later time when sending your product for repair or other purposes. Always use these packing
box and cushion material when transporting this product.
* If any of these items are missing or found faulty, please contact your local distributor.
* If there is any question or doubt about the packaged product, contact your local distributor.
* For purchasing the IC61-1004-051 or for technical information, contact Yamaichi Electronics
Co., Ltd.
2.2 Other Tool Products Required for Development
To bring forward programs development on an M16C/62 Group M16C/62N and M16C/30 Group
M16C/30L, the products listed below are necessary in addition to those contained package above. Get
them separately.
Table 2.2 Other tool products
* To purchase these products, contact your local distributor.
Chapter 2. Preparation
2.1 Package Components
The M3062NT3-RPD-E package consists of the following items. When unpacking, check to see if
your M3062NT3-RPD-E contains all of these items.
Table 2.1 Package components
Emulator main unit
Emulator debugger
Converter board
PC4701 (excluding PC4701L and PC4700L)
M3T-PD30
For 80-pin 0.65-mm-pitch QFP (80P6S-A):
M3T-100LCC-DMS + M3T-FLX-DCT613 + M3T-FLX80QSB
M3T-100LCC-DMS + M3T-FLX-DCT613 + M3T-DIRECT80S
For 100-pin 0.65-mm-pitch QFP (100P6S-A):
M3T-100LCC-DMS + M3T-DIRECT100S
M3T-100LCC-DMS + M3T-DUMMY100S
M3T-100LCC-DMS + M3T-FLX-100NRB
For 100-pin 0.5-mm-pitch LQFP (100P6Q-A):
M3T-F160-100NSD
M3T-100LCC-QSD
M3T-100LCC-DMS + M3T-FLX-100NSD
For 100-pin 0.4-mm-pitch TQFP (100PFB-A):
M3T-F160-100NSE
Required according to the foot pattern of the target system (see "3.8
Connecting the Target System" on page 41)
Item
M3062NT3-RPD-E emulation pod main unit
FLX120-RPD flexible cable for connecting PC4701
M3T-F160T3-PRB converter board for M3T-FLX160C (preinstalled)
M30800T-PTC converter board for 100-pin 0.65-mm-pitch QFP
IC61-1004-051 100-pin 0.65-mm-pitch LCC socket (made by Yamaichi Electronics Co., Ltd.)
OSC-3 16 MHz oscillator circuit board for main clock (preinstalled)
OSC-2 oscillator circuit board for main clock (bare board)
Resistor arrays for pulling up ports P0 to P5 (51 kΩ)
Hardware tool user registration FAX sheet
Hardware tool user registration FAX sheet (Japanese)
M3062NT3-RPD-E User's Manual (This manual)
M3062NT3-RPD-E User's Manual (Japanese)
Quantity
1
1
1
1
1
1
1
6
1
1
1
1