Filter
Top Products
( 48 / 84 )
Figure 3.19 Connecting to a 100-pin 0.5-mm-pitch foot pattern (part 1)
CAUTION
Notes on Connecting the Target System:
• Take care not to attach the converter board in a wrong direction. It may cause a fatal
damage to the emulation pod.
• The connector of the M3T-F160-100NSD is guaranteed for only 50 insertion/
removal iterations.
(7) Connecting to a 100-pin 0.5-mm-pitch Foot Pattern (Part 1)
Here follows how to connect the emulation pod probe to a 100-pin 0.5-mm-pitch foot pattern on the
target system with the M3T-F160-100NSD (not included). For details on the M3T-F160-100NSD
(not included), refer to its user's manual.
(1) Mount the NQPACK100SD included with the M3T-F160-100NSD to the target system.
(2) Attach the YQPACK100SD included with the M3T-F160-100NSD to the NQPACK100SD,
and secure it with YQ-GUIDE's.
(3) Attach the CN2 side of the M3T-F160-100NSD to the tip (CN2 side) of the pitch converter
board connected to the emulation pod probe.
(4) Attach the M3T-F160-100NSD to the YQPACK100SD.
Onboard evaluation
HQPACK100SD
(not included)
Flash version MCU etc.
100-pin 0.5-mm-pitch (100P6Q-A) foot pattern
These four parts are in one package.
These corners are not round.
CN2 side
YQ-GUIDE's (x4)
YQPACK100SD
NQPACK100SD
M3T-F160-100NSD (not included)
Target system
No. 1 pin
(4)
(3)
(1)
(2)
Tip of pitch converter board
Tip of emulation pod probe