Filter
Top Products
26
Speed
Set the cutting speed. Usually setting a lower speed will result in longer cut times, but will produce
higher quality results.
Force
This sets the cutting pressure.
For more information about settings for cutting, go to the PC-12 User's Manual, and in "Part 3 Getting
Ready," refer to "3.4 Installing and Adjusting the Blade."
Feed
This adjusts the amount of feed for cutting. The amount of adjustment when set at the maximum value
of 50 is approximately 1.5%.
X-Position
This adjusts the cutting position in the vertical direction. The amount of adjustment when set at the
maximum value of 50 is approximately 3mm(1/8 in.).
Y-Position
This adjusts the cutting position in the vertical direction. The amount of adjustment when set at the
maximum value of 50 is approximately 3mm(1/8 in.).
For more information about Cutting Feed, Cutting X Position, and Cutting Y Position, go to the PC-12
User's Manual, and in "Part 5 Many Kinds of Printing and Settings," under "5.2 Driver Settings," refer to
"Adjusting a [Media Type] Item."
Reset
This restores values to their defaults.
The Color Tab
The Color tab displays settings associated with the color quality of the image. Using the sliders on the tab, you
can adjust the image quality. The sliders that appear vary, depending on which color mode is selected on the
Print tab. In all modes, you can adjust the overall image contrast using the Contrast slider.