Filter
Top Products
T
ROUBLESHOOTING
9.10
[No Paper]
Add Paper
The paper tray has run out
of paper.
Load paper in the paper tray.
See page 1.12.
Operation Not
Assigned
You are doing in the Add/
Cancel operation, but there
is no jobs waiting.
Check the display to see if there
is any scheduled job. The display
should indicate them in Standby
mode, for example, Delay Fax.
[Paper Jam 0]
Open/Close Door
Paper has jammed in the
feeding area of the paper
tray.
Clear the jam. See page 9.4.
[Paper Jam 1]
Open/Close Door
• Paper has jammed in
the paper exit area.
• A paper jam has
occurred in the manual
feeder or the machine
detects non-feeding
from the manual feeder.
Clear the jam. See page 9.6.
[Paper Jam 2]
Check Inside
Paper has jammed in the
fuser area.
Clear the jam. See page 9.5.
Power Failure
Power has turned off then on
and the machine’s memory
has not been saved.
You need to start again the job
which you were trying to do
before the power failure.
Retry Redial?
The machine is waiting for a
specified time interval to
redial a previously busy
station.
You can press
Enter
to
immediately redial, or
Stop/
Clear
to cancel the redial
operation.
[Stop Pressed]
The
Stop/Clear
button is
pressed during a copy or fax
operation.
Try again.
[Toner Empty]
The toner cartridge has run
out. The machine stops
printing.
Replace with a new toner
cartridge. See page 8.9.
[Toner Low]
The toner cartridge is almost
empty.
Take out the toner cartridge and
gently shake it. By doing this,
you can temporarily reestablish
printing operations.
Display Meaning Suggested solutions