Filter
Top Products
INSTALLATION AND SETUP
C
HAPTER
T
WO :
I
NSTALLATION AND
S
ETUP
2.3
1
Open the cover by lifting
the release lever on the
side of the fax machine.
2
Insert the paper roll.
3
Install the spacer, if
necessary.
A
B
SPACER
Installing Paper
Your machine must have a roll of paper installed in order to operate. Find the paper roll
included with the parts, and follow the directions below:
Ã
If there is an adhesive sticker
sealing the paper roll, remove it
completely.
The outer diameter of the paper roll
should not exceed 2.05 in/52 mm.
(total length of the paper roll is
approximately 98.4 ft/30 m.)
Ã
If your paper roll is 8.5 in/216 mm
wide (letter size), the spacer should be
in position ÒAÓ. For narrow paper (A4
size, 8.27 in/210mm), place the spacer
in position ÒBÓ, pushing its pins into
two small holes on the right-hand wall
of the paper compartment.
4
Pull the paper end past
the edge of the fax
machine.
Ã
Be sure the paper exit over the top
of the roll as shown.
EURO(M)-Chapter 2 3/26/98 3:22 PM Page 4