Filter
Top Products
56
Choose the running speed of cooling fans from the following
options.
Normal ....... Normal speed.
Max ........... Faster than the normal speed.
Fan control
Setting
Filter control
You can replace the filter with this function. Press the SELECT
button at Filter control to display a confirmation box. To replace,
press the SELECT button at “YES” and the electrically operated
filter starts to scroll.
You can also replace the filter by using the remote control
(p.31).
✔Note:
• Filter replacement icon and “Please wait...”
message appear on the screen when the filter is
being scrolled.
•The filter cannot be rewound.
•
When the filter is replaced, the total accumulated
time of the filter use is automatically set to 0.
• If the filter cartridge is not installed in the projector,
'Filter control' is displayed in grayout.
RC sensor
Select a location of the infrared remote receiver of the remote
control. See “Remote Control Receivers and Operating Range”
on page 15 for details.
All . . . . . . . . . . .Activate all of the front, top and back receivers.
Front & Top . . . .Activate the front and top receivers.
Top & Back . . . .Activate the top and back receivers.
Front & Back . . .Activate the front and back receivers.
Front . . . . . . . . .Activate only the front receiver.
Top . . . . . . . . . .Activate only the top receiver.
Back . . . . . . . . .Activate only the back receiver.
Remote control
Remote control
When pressing the SELECT button at
Remote control, the Remote control
code menu appears.
The eight different remote control codes (Code 1–Code 8) are
assigned to the projector; the factory-set, initial code (Code 1)
and the other seven codes (Code 2 to Code 8).
The same code should be set on both the projector and the
remote control. For example, operating the projector in “Code
7”, the remote control code also must be switched to “Code 7”.
To change the code for the projector;
Select a remote control code in this Setting Menu.
To change the code for the remote control;
Check the Reset Switch to "Use position" in the compartment
lid on the back of the remote control.
And then while holding down the MENU button, press and
release the IMAGE ADJ. button the number of corresponding
times you would like to set the number of the remote control
code for the projector. (See page 16)
To reset the code for the remote control;
Slide the Reset Switch to "Reset position" in the compartment
lid on back of the remote control.