Filter
Top Products
75
WARNING:
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you purchased the projector
or the service center. Specify the model number and explain about the problem. We will advise you how to obtain
service.
This symbol on the nameplate means the product is Listed by Underwriters
Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety
standards against risk of fire, casualty, and electrical hazards.
The CE Mark is a Directive conformity mark of the European Community (EC).
Pixelworks ICs used.
Appendix
The power is turned off
automatically.
– Power management function runs by initial setting. Check “SETTING” section on page
57.
You cannot operate with
the side control.
– The side control is not available If the side control is locked at “Key lock” under
“Security” of SETTING section. Please check “SETTING” section on page 58.
The Remote Control does
not work.
– Check the batteries.
– Check if the RC sensor is set properly. (See page 56)
– Make sure no obstruction is between the projector and remote control.
– Make sure you are not too far from the projector when using the remote control.
Maximum operating range is 16.4’ (5m).
– Make sure that the remote control code conforms to the projector’s code.
(See “SETTING” section on page 56.)
– Make sure the reset switch in the compartment lid on back of the remote control is set
to use position.
– Unlock the Key lock function for the remote control. (See page 58)
– Wireless remote control does not work when the remote control cable is connected to
the projector. (See page 15)
Indicators blinks or lights.
– Check the status of the projector with referring to “ INDICATORS AND PROJECTOR
CONDITION” on pages 79-81.
appears on the screen
– Your operation is invalid. Operate correctly.
Unable to unlock the Logo
PIN code lock, Security
key lock or Security PIN
code lock.
– Contact the dealer where you purchased the projector or the service center.
Forget the Logo PIN code
or Security PIN code.
– Contact the dealer where you purchased the projector or the service center.