Filter
Top Products
70
Maintenance and Care
Optional Color Wheel Installation
The projector comes with the high brightness color
wheels installed. Additional rich color reproduction
color wheels are supplied. To replace the color wheels,
refer to the following steps.
✔Note:
•
Wait until the lamp house and the color wheel cool off.
•
Make sure to install the same type of two color wheels at
the same time. When different types of color wheels are
installed, ‘Non-matching color wheels!‘ message appears
on the screen.
Allow the projector to cool, for at least 45 minutes
before you open Lamp Cover. The inside of the
projector can become very hot.
Loosen a screw on the Lamp Cover. Slide and open the
Lamp Cover. (See the right figure.)
1
3
Loosen three screws and pull out the color wheel to be
replaced by grasping handle.
4
Turn off the projector, press the Main On/Off Switch to Off
and unplug the AC power cord from the AC outlet. Let the
projector cool for at least 45 minutes.
2
Replace the color wheel with a new one and tighten three
screws. Make sure the color wheels are set properly.
Put the Lamp Cover back and tighten a screw.
5
SCREW
LAMP
COVER
SCREWS
COLOR WHEELS