Filter
Top Products
KVM Switch KVM2132P, KVM2116P, KVM1116P User Manual 70
IPv6 Settings
IP Address:
IPv6 is the new (128-bit) format for specifying IP addresses. (See “IPv6” on page 106 for further
information.) The KVM switch can either have its IPv6 address assigned dynamically (DHCP), or it can
be given a fixed IP address.
• For dynamic IP address assignment, select the Obtain IP address automatically radio button.
(The default setting.)
• To specify a fixed IP address, select the Set IP address manually radio button and fill in the
fields with values appropriate for your network.
DNS Server
• For automatic DNS Server address assignment, select the Obtain DNS Server address
automatically radio button.
• To specify the DNS Server address manually, select the Set DNS server address manually radio
button, and fill in the addresses for the Preferred and Alternate DNS servers with values
appropriate for your network.
Note: Specifying the Alternate DNS Server address is optional.
Network Transfer Rate
This setting allows you to tailor the size of the data transfer stream to match network traffic conditions
by setting the rate at which the KVM switch transfers data between itself and the client computers. The
range is from 4-99999 Kilobytes per second (KBps).
Finishing
Be sure to enable Reset on exit on the Device Management > System Operation page (see “Reset on
exit” on page 94), before logging out to allow network changes to take effect without powering the
switch off and on.
ANMS
Use ANMS (Advanced Network Management Settings) to set up login authentication and authorization
management from external sources. It is organized as a notebook with two tabs, each with a series of
related panels.
Event Destination.
SMTP Settings
To have the KVM switch email reports from the SMTP server to you:
1. Enable the Enable report from the following SMTP server, and enter the IPv4 address, IPv6
address, or domain name of the SMTP server.
2. If your server requires a secure SSL connection, put a check in the My server requires secure
connection (SSL) checkbox.
3. If your server requires authentication, put a check in the My server requires authentication
checkbox, and enter the account information in the Account Name and Password fields.
4. Enter the email address where the report will be sent in the From field. Put only one email
address in the From field. It cannot exceed 64 Bytes.
5. Enter the email address (addresses) where you want the SMTP reports sent in the To field.
Note: If the report will be sent to more than one email address, separate the addresses
with a semicolon. The total cannot exceed 256 Bytes.