Filter
Top Products
Hawk 2XL Family Installation Guide, Rev. C 33
_______________________________________________
• Setup presents a menu. Choose the menu item that asks
you to declare the drive type. If the screen says the drive
type is "not installed" or something similar, save that and leave
setup. If it asks you to enter a drive type, enter "none," "drive
not installed," "type 0" or whatever similar response is given
as a choice on the menu.
• Save and leave this screen. The computer will probably boot
up again. If not, hit CTL-ALT-DEL.
• At the C> prompt or A> prompt, run the FDISK utility pro-
gram either from your existing hard drive or from a diskette in
drive A. (refer to your DOS user's Reference Manual for more
detailed instructions on FDISK procedures).
• A menu comes up that gives choices pertaining to installing
your new drive and dividing it into partitions. If the drive you
set the jumpers for is Drive ID 0 (no ID jumpers on), the menu
will stay at the top, "Current fixed disk drive: 1"
• From the menu choose "Create a DOS partition..."
• Proceed to set up desired partitions.
• If your new drive is jumpered as Drive ID 1, choose "Select
next fixed disk drive" on the menu. FDISK displays the main
menu again, but at the top it says "Current fixed disk drive:
2".
• The menu displayed gives you the same opportunity as men-
tioned above to partition your second drive as several logical
(simulated) drive volumes.