Filter
Top Products
4 Hawk 2XL Family Installation Guide, Rev. C
_______________________________________________________________________________________________________________________
• A SCSI* host adapter card for the PC
You may need this if your computer does not already have a
hard drive, if your present drive does not connect to a SCSI
host adapter, or if your present SCSI adapter card cannot
address a drive having the capacity the Hawk 2XL has.
The host adapter card should have instructions with it for
installing the card and assist in the installation of hard disc
drives that it supports.
• A 50-pin SCSI interface cable
You will need an interface cable if your computer does not
presently contain a SCSI hard drive. If you are adding a sec-
ond hard drive you must use an interface cable that has two
drive connectors, one on the end and one in the middle. See
Figure 1.
• A Y-shaped drive power cable
You may need this if your computer does not have enough
power cables to supply power to your new hard drive. See
Figure 2.
• Mounting screws
You will need four 6-32 x 1/4 inch (6.4 mm) nonmetric screws
if you mount your drive directly into the drive bay. See Safety
Instructions for maximum screw length (see Figure 6).
• Drive mounting rails
You may need drive rails if your computer's drive bay is not
designed for direct mounting.
* These drive models use the industry standard SCSI interface.