Filter
Top Products
• M.LF/M.RLF (Micro line feed/micro reverse line feed)
When the M.LF/M.RLF key is pressed, the paper is fed 1/360 inch forward
or backward, respectively. This key is used to set the paper position.
To set the TOF SET (top-of-form set) function, press the FF key and then
simply advance the loaded paper forward or reverse to your desired print
position using the M.LF/M.RLF keys. Hereafter until you reload paper, the
first print position of the form is always fed at the same place.
• TEAR OFF [Used only for fanfold paper]
Pressing this key advances the perforation of the form to the paper cutter so
that the leading form can be torn off from the rest.
If this key is pressed after the form is torn off, the paper is fed backwards
and the mode is returned to offline. If the ON LINE key is pressed instead
of the TEAR OFF key, the paper is fed backwards and the mode is changed
to the online mode.
• PARK (Paper parking)
Pressing this key unloads the paper if the paper is already loaded and loads
the paper when the paper is not already loaded.
Fanfold continuous paper (paper select lever in fanfold setting)
The paper is moved to the park station in the back of the printer by pressing
this key. When pressing this key with the paper in the park position, the
paper will be loaded to the print station between 0 and 8 inches from the top
edge of the paper, depending on the loading position (TOF Adjust) selected
in the basic setup options on page 31.
Single sheet paper (paper select lever in single sheet setting)
The paper in the print station will be ejected. When paper is in the paper
rack, the paper is moved to the print station by pressing this key.
• BIN (ALT+SETUP keys)
This key is for selecting the active paper tray of the cut sheet feeder or the
paper feed type:MANUAL, BIN1, BIN2 or BIN1+2. BIN1, BIN2, BIN1+2
appears only when the cut sheet feeder (CSF) option is set.
+
TEAR OFF
PARK
TOF SET
M.RLF
M.LF
18
3. Control panel and operations
BIN
SETUP
EXIT
ALT
ENTER
Note
The paper select lever must be switched to the single sheet setting.