Filter
Top Products
GS :
[Name]
Set starting/ending of macro definition
[Format]
<1D>H<3A>H
[Description]
Specifies the starting or ending of the macro definition.
If this command is received while defining the macro, it ends the
definition.
[Notes]
l
If the macro range exceeds 2048 bytes, the exceeds data is not
defined.
l
Even if the ESC @0 command (initialize the printer) is performed,
the macro definition is not cleared. Therefore, it is possible to
include ESC @ in the macro definition.
l
Normal printing operation is possible while defining the macro.
[Default] Macro is not defined.
[Reference] GS
GS <
[Name]
Initialize printer mechanism
[Format]
<1D>H<3C>H
[Description] Positions the label for printing.
[Notes]
l
This command takes effect on the third and following labels.
This is because the difference in detection level between label
and base sheet is determined using the first label on a sheet
and the label length and distance between labels using the sec-
ond label.
l
Because the maximum label length is 4 inches, any labels ex-
ceeding 4 inches in length will cause error.
l
The contents set by commands will not change.
GS A m n
[Name]
Adjust label paper position to start printing
[Format]
<1D>H<41>H<m><n>
[Range]
0
≤
m
≤
255
0
≤
n
≤
255
[Description]
Sets the label position in terms of adjustment amount against
default position.
45