Filter
Top Products
n1 x 2 ms
n2 x 2
ms
Figure B-1. Drawer Kick-out Drive Signal
Printer side
User side
Figure B-2. Drawer Kick-out Signal Interface Circuit
NOTES:
l
The circuit on the user side should be designed so that the drawer
drive duty is as shown below.
ON time
≤ ≤
0.2
ON time + OFF time
l
The waveform shown in Figure B-l is output at Point A in Figure B-2
(n1 (ON time) and n2 (OFF time) depend on the
ESC p
command.)
APPENDIX C Interfaces
1. Specifications (RS-232C compatible)
Data transmission:
Synchronization:
Handshaking:
Signal level:
Baud rates:
Bit length:
Parity:
Stop bits:
Connector:
Serial
Asynchronous
DTR/DSR or XON/XOFF control
MARK = -3 to -15 V:
Logic “1”
SPACE = +3 to + 15 V: Logic “0”
1200,4800,9600,19200 bps
8 bits
Invalid, even, odd
1 bit or more
D-SUB 25 pin connector
67