Filter
Top Products
With count-down
l
Counts down n1 + n2 x 256 > n3 + n4 x 256, n5
≠
0, and n6
≠
0.
l n1 + n2 x 256 means the maximum counter value and n3 + n4 x
256 the minimum counter value.
To stop counting
l Stops counting if n1 + n2 x 256 = n3 + n4 x 256, n5 = 0, or n6 =
0.
[Notes]
l
n5
indicates the stepping amount when counting up or down.
l n6 indicates repetition number with the counter value being
fixed.
l
When this command is issued, the inner counter that indicates
the repetition number specified by
n6
will be cleared.
With count-up
l If counting up reaches a value exceeding the maximum, it is
resumed with the minimum value.
With count-down
l
If counting down reaches a value less than the minimum, it is
resumed with the maximum.
[Default]
n1 + n2 x 256 = 1, n3 + n4 x 256 = 65535, n5 = 1, n6 = 1
[Reference]
GS CO, GS C2, GS c, GS C;
GS C2 n1 n2
[Name] Set counter
[Format]
<1D>H<43>H<32>H<n1><n2>
[Range]
0 ≤ n1 ≤ 255
0 ≤ n2 ≤ 255
[Description]
Sets the value of the serial number counter.
l
n1 +
n2
x 256 is the counter value.
[Notes]
l When this command is issued, the inner counter that counts
repetition number with the counter value fixed will be cleared.
With counting up
l
If the counter value set by this command goes out of the counter
operation range set by GS Cl or GS C;, it will be forced to
convert to the minimum value by GS c.
With counting down
l
If the counter value set by this command goes out of the counter
operation range set by GS Cl or GS C;, it will be forced to
convert to the maximum value by GS c.
48