Filter
Top Products
55
TROUBLESHOOTING
6
Paper size for a paper tray cannot
be set.
Copying or printing is performed.
→ Set the paper size after copying or printing is complete.
–
The machine has stopped temporarily due to running out
of paper or a misfeed.
→ Load paper or remove the misfeed, and then set the paper size.
14, 63
An interrupt copy job is in progress.
→ Set the paper size after the interrupt copy job is finished.
31
The display or the ORIGINAL DATA indicator is blinking.
→ Data is being held in memory. Print the data in memory or clear it
from memory.
33, 35
A copy job stops before it is
finished.
The paper output tray is full.
→ Long copy runs are automatically paused every 250 copies.
Remove the copies in the paper output tray and press the
[START] key ( ) to resume copying.
22
"FUL" appear in the display.
→ The memory became full during sort/group copy or 2 IN 1 / 4 IN 1
copy. Copy only the originals that have been scanned to that
point, or cancel the job and clear the data from memory.
33, 35
The tray is out of paper.
→ Load paper.
14
A paper feed location is blinking.
→ A blinking paper feed location means that the size of paper
loaded in the tray is different from the paper size setting for the
tray. Change the paper size setting, open and close the tray, and
then press the [CLEAR] key ( ) or [CLEAR ALL] key ( ).
16
The POWER SAVE indicator is lit.
Any other indicators are lit.
→ If other indicators are lit, the machine is in "Preheat mode". Press
any key on the operation panel to resume normal operation.
12
The POWER SAVE indicator is only lit.
→ If only the POWER SAVE indicator is lit, the machine is in auto
power shut-off mode. Press the [START] key ( ) to resume
normal operation.
12
Any of the alarm indicator
( , , , , ) is lit or
blinking.
See "INDICATORS AND DISPLAY MESSAGES" to check
the meaning of the alarm indicator and error message in
the display, and take appropriate action.
62
Lighting fixture flickers.
The same power outlet used is for the lighting fixture and
the machine.
→ Connect the machine to a power outlet which is not used for other
electric appliances.
–
Problem Cause and solution Page