Filter
Top Products
70
REPLACING THE TONER CARTRIDGE
When the toner cartridge replacement required indicator ( ) lights up, the toner cartridge will need replacement
soon. Obtain a new cartridge. When the toner cartridge replacement required indicator ( ) blinks, the toner
cartridge must be replaced before copying can be resumed.
Replace the toner cartridge by following the procedure below.
1
Push on both ends of the front cover
and open it.
2
Pull the toner cartridge out while
pressing the lock release lever.
3
Remove the new toner cartridge from
the bag. Grasp the cartridge on both
sides and shake it horizontally four or
five times. After shaking the cartridge,
remove the tape.
4
Insert the toner cartridge along the
guides until it locks in place while
pushing the lock release lever.
If there is any dirt or dust
on the toner cartridge,
remove it before
installing the cartridge.
5
Remove the tape from the shutter. Pull
the shutter out of the toner cartridge.
Discard the shutter.
6
Close the front cover.
The toner cartridge
replacement required
indicator ( ) will go
out.
When the toner cartridge replacement indicator ( ) blinks, little toner remains and thus copies may be faint.
Note
After removing the toner cartridge, do not
shake it or tap on it. Doing so may cause
toner to leak from the cartridge. Put the old
cartridge immediately in the bag contained in
the box of the new cartridge. Dispose of the
old toner cartridge in accordance with local
regulations.
• Grasp the grip when holding the cartridge.
Do not hold the cartridge by the shutter.
• Be sure to shake the cartridge only before
the tape is removed.
Toner cartridge
lock release lever
Caution
Shutter
tape
4 or 5 times
Caution
• Even after a new toner cartridge is installed,
the toner cartridge replacement required
indicator ( ) may still light up, indicating
that copying cannot be resumed (toner is
not fed sufficiently). In this case, open and
close the front cover. The machine will feed
toner again for about two minutes and then
copying can be resumed.
• Before closing the front cover, make sure
that the toner cartridge is correctly installed.
• When closing the front cover, press on both
ends.
Note