Filter
Top Products
KEY OPERATOR PROGRAMS
8-7
8
ECM
(This setting is only effective if the other machine
is a G3 machine that supports ECM)
Line conditions can sometimes distort a
transmitted fax image. When ECM (Error
Correction Mode) is turned on, pages that are
distorted are automatically re-transmitted. This
setting is initially turned on. If turned off, distorted
images will be transmitted without being corrected.
Distinctive ring detection
This program can only be activated in Canada,
Australia, and New Zealand.
If multiple telephone numbers have been assigned
to your telephone line, the number called can be
identified by its ringing pattern. By using one
number for voice calls and another number for
faxes, you can tell which type of call you are
receiving by the ringing pattern. You can set your
machine to automatically receive faxes when your
fax number is called by setting the pattern that
corresponds to your fax number. (Note that in
Canada, six selections are available.) Normally
OFF is selected.
Disable of fax number direct entry
When the fax function is enabled, this program is
used to prohibit dialing of a destination fax number
by direct entry with the numeric keys. To prohibit
dialing by direct entry with the numeric keys, touch
the checkbox to select it. When this is done, faxes
can only be sent to destinations that have been
stored, and thus this program can be used to
restrict fax destinations and prevent accidental
transmission to an incorrect number. The following
operations are also prohibited:
Storing one-touch dial numbers
Direct entry of fax numbers when storing a group
Direct entry of fax numbers of relay destinations in
a relay broadcast memory box
Fax send settings
The fax transmission settings allow you to adjust
certain parameters for sending faxes to better suit
your needs.
The fax send settings are as follows:
Auto reduction sending setting
Rotation sending setting
Printing page number at receiver
Call timer at memory sending
Date/own number print position setting
Quick on line sending
Recall in case of line busy
Recall in case of communication error
Auto reduction sending setting
This setting lets you select whether to have a
transmitted document reduced to match the size of
the other machine's printing paper. Auto reduction
is normally turned on. If the setting is turned off,
documents are sent in their original size. Because
the size is not adjusted to match the size of the
printing paper, part of the received document may
be cut off.
Rotation sending setting
When transmitting a document, this setting allows
you to rotate a vertically oriented A4 (8-1/2"x11")
document to a horizontal orientation (A4R
(8-1/2"x11"R)), rotate a B5R (5-1/2"x8-1/2R")
document to B5 (5-1/2"x8-1/2"), or rotate a A5R
document to A5. The setting is normally turned on,
and documents are rotated counterclockwise.
(A4R (8-1/2"x11"R) documents are not rotated.)
Rotation settings can be separately established for
different document sizes. To turn off a rotation
setting, touch the checkbox of the appropriate
setting to remove the checkmark.
Printing page number at receiver
This setting lets you select whether page numbers
are printed at the top of fax pages by the receiving
machine. The normal setting is to have page
numbers printed.
NOTE
If the other machine supports Super G3, ECM will
function regardless of the setting.
KEY OPERATOR PROGRAMS
ROTATION SENDING SETTING
A4
B5
ORIGINAL
SET
SENDING
DIRECTION
OK
B5R
A4R
B5
A5R
A5