Filter
Top Products
Loading the Imaging Film
17
1. Installation
6
Pull the empty spool toward the back
of the compartment, unwinding the
film as you pull.
5
Cut the band which holds the spools
together with scissors, and remove it.
Insert the remaining gear into the
right end of the empty spool and the
flange into the left end of the empty
spool. Make sure the tabs on the gear
and the flange fit into the slots in the
ends of the spool (the gear has two
tabs and the flange has one tab).
7
Insert the empty spool into the back
of the compartment so that the gear
and the flange fit into the slots on the
sides of the compartment.
• Make sure that the gear engages
with the gear below it.
1 tab
2 tabs
Flange
Gear
8
Wind the film slightly (rotate the gear
on the right side of the empty spool)
so that there is no slack in the film.
Make sure that both edges of the film
wind onto the spool evenly.
all-ux510A.book Page 17 Thursday, September 14, 2000 9:05 AM