Filter
Top Products
Setting Up and Using OpenLCR
41
2. Setting Up
OpenLCR
“E” indicates that the rate
data is out-of-date.
What to do if “E” appears in the display
A highlighted “E” will appear in the display in place of “C” if the rate
data in the fax is out-of-date and the fax is unable to obtain new data.
When this happens, OpenLCR routing will not take place.
This will only occur if the fax machine is unable for some reason to
make its periodic call to OpenLCR to receive new rate data.
First try downloading the rate data manually by pressing the
OpenLCR key and 2 key as explained in Downloading (receiving)
the rate data manually on page 35. If this doesn’t work, proceed to the
following section, What to do if you cannot connect to OpenLCR.
What to do if you cannot connect to OpenLCR
If you are unable to connect to OpenLCR when you use the OpenLCR
key to register or manually download data, it is likely that the phone
number that the fax machine dials when you press the OpenLCR key
is no longer correct.
To obtain the correct phone number, call OpenLCR at 970-206-1207,
and then program the number into the fax machine as explained on the
following page.
♦ Note: The number that you will obtain is the number for manually
downloading rate data (dialed by pressing the OpenLCR key and
2). When you manually download the rate data, the new numbers
for registering (dialed by pressing the OpenLCR key and 1, 3, or 5)
will also be programmed in your fax machine.
JAN-19 02:16
all-ux510A.book Page 41 Thursday, September 14, 2000 9:05 AM