Filter
Top Products
Setting Up and Using OpenLCR
34
4
Follow the instructions you hear.
♦ Note: If you are on a pulse dial line, press the * key before
pressing the number keys to respond.
(This makes your fax temporarily issue tone signals when you press
the number keys.)
♦ When registration is completed, your fax machine will receive the
rate data from OpenLCR. This will last one or two minutes. When
downloading is completed, the display will briefly show
DOWNLOAD OK!! and then revert to the date and time.
♦ OpenLCR will also program the date and time and your fax number
in your fax machine.
Registering through OpenLCR’s Web site
You can also register at OpenLCR’s Web site, www.OpenLCR.com.
After registering you will need to receive the rate data manually
(service is not activated until your fax receives the rate data). See
Downloading (receiving) the rate data manually on the following
page.
The rate data that you receive is based on the address you provide when
registering with OpenLCR. If you move, the rate data will not be correct for
your new location. In this case, repeat the registration procedure to give
OpenLCR your new address.
Note: If you wish to connect more than one OpenLCR-enabled device to
the same line, please call OpenLCR at 970-206-1207.
If you move, you
must re-register!
all-ux510A.book Page 34 Thursday, September 14, 2000 9:05 AM