Filter
Top Products
Setting Up and Using OpenLCR
43
2. Setting Up
OpenLCR
Selecting a long or short call
Before you make a long distance or international phone/fax call, select
whether the call will be a long call or a short call.
1
Press these keys:
The display will show:
LCR TABLE SELECT
1=02MIN, 2=04MIN
2
Press 1 to select the SHORT TIME
setting, or 2 to select the LONG
TIME setting.
• The initial SHORT TIME setting is 2
minutes, and the initial LONG TIME
setting is 4 minutes. If desired, you
can change these settings as explained
on the following page.
• The short/long time selection will
remain in effect for all calls until you
change it.
or
SHORT LONG
Note: If the display shows
TABLE NOT EXIST, you
must first download the rate
Note: The following settings are not required as of the printing date
of this manual. OpenLCR will inform you through its Web site
(www.OpenLCR.com) if the settings become necessary in the future.
OpenLCR
FUNCTION
Your fax needs to know
whether the call will be
long or short to route it
for the best rate.
1
2
all-ux510A.book Page 43 Thursday, September 14, 2000 9:05 AM