Filter
Top Products
Receiving a Phone Call
37
2. Cordless
Handset
Receiving a Phone Call
1
When the cordless handset rings, pick it up and press to answer.
Talk to the other party.
2
When you are ready to end the call, press .
• If the END CALL setting is set to “ON” (see page 53), you can also end the
call by simply placing the cordless handset in the charger. (The call will end
even if it has been placed on hold.)
Putting a Call on Hold
To put the other party on hold during a call, press . While the call is on
hold, “C” will blink in the display. When you are ready to resume the call,
press once again.
♦ If the END CALL setting is set to “ON” (see page 53), placing the cordless
handset in the charger will end the call, even if the call is on hold.
♦ If the END CALL setting is set to “OFF”, placing the cordless handset in the
charger will not break the connection while a call is on hold, and thus phone
charges may continue to apply.
You can also dial by entering the phone number first and then pressing .
♦ Check the number in the display before pressing . If there is a
mistake, press to clear the mistake and then enter the correct
digits.
Note: If a pause is needed between any of the digits to access an outside
line or a special service, hold down until “ ” appears.
_FO-D60A_English_E4432.book Page 37 Thursday, February 19, 2004 1:42 PM