Filter
Top Products
10
Precaution: The paper cutter is mounted on the printer cover. Take caution when removing and installing
the cover.
The register can print receipts and journals. For the printer, you must install the paper rolls (receipt and journal
paper rolls) provided with the register.
Install the paper rolls according to the procedure shown below with the power cord connected and the mode
switch set to the REG position:
1. Cut off approximately one revolution of each paper roll.
Make sure each paper end is cut as per the diagram.
2. Lift up the print roller release lever
(indicated as "PULL" on it) of the
receipt side to unlock and open the
print roller arm.
3. Set a paper roll in the paper roll cradle of the receipt side as
per the diagram.
4. Feed the end of the paper along with
the paper positioning guides as per
the diagram.
5. While holding down the paper, slowly close the print roller arm
of the receipt side, and push down the "PUSH"-indicated part
of the arm until you hear a click locking the arm. Make sure
securely you push down the center of the wing part of the arm
as per the diagram. The paper will be fed automatically.
If the print roller arm is not securely locked, printing
is not done right. If this problem occurs, open the
arm, and close the arm as instructed above.
To the printer
Incorrect
To the printer
Correct
Print roller arm
(Receipt side)
Paper positioning guides
3
Installing Paper Rolls
Correct Incorrect
Print roller release lever
(Receipt side)
A303_1(En) 06.7.22 9:20 AM Page 10