Filter
Top Products
Finalizing the Installation 37
When you receive the 4000i, the projector settings are optimized for you. However, if these
settings are altered, you may need to reset them (see page 55).
The Network ON setting allows the projector to go into standby mode instead of completely
powering down. With this setting, you can activate the projector by pressing the convenient
Projector Standby button on the 4000i’s control panel, instead of using the projector or
remote control power buttons to turn the projector on or off.
When you press the Projector Standby button, you turn on the projector lamp if it’s off or, if
it’s on, you either put it into the reversible standby mode or into the cooling mode. (For details
on using the Projector Standby button, see page 42.)
If you must restore the Standby Mode setting to Network ON, follow the procedures on
page 55. For information on the states of the projector, see Table 1 on page 7. To learn more
about what happens when you press the Projector Standby button, see Table 2 on page 42.
Your projector lamp should last 7,000 hours. However, to help conserve lamp life, we’ve
configured the projector to shut off its lamp if a video signal isn’t received for 30 minutes.
NOTE: You should cover the projector lens with the lens cap and disconnect the cabinet from
the power source if you won’t use the computer and projector for an extended time period. See
page 48 for instructions on when it’s safe to unplug the projector or the cabinet.
Installing SMART Board Software
The 4000i comes with a SMART Board software CD-ROM, so you can install SMART Board
software on any computer.
During this installation process, you should select the option to start the SMART Board tools
automatically when you start your computer, so the interactive whiteboard is fully functional
whenever you start your computer.
The SMART Board tools are open if you can see the SMART Board icon in the system tray
(Windows computers) or in the Dock (Macintosh computers).
Recommended projector settings
IMPORTANT
Do not modify the following projector settings:
• Standby Mode, which must be set to Network ON
• Contrast, which must be set to Manual
Projector Standby Button
SMART
Board
Icons