Filter
Top Products
System Monitoring
The TigerSwitch 100 units can be monitored using either the
front-panel Configure Button and LEDs, SNMP and Telnet or the
Console Interface.
Monitoring via the Configure Button and LEDs
The Configure button may be used with the front-panel LEDs to
display various system operations characteristics. To set the
display mode using the Configure button:
1. Use a long press (>2 sec) to initiate display functions. The
“Status” LED will begin blinking upon release of the button.
(See Chapter 1, “About the TigerSwitch 100,” for an
illustration of the front-panel LEDs)
2. Once the “status” LED is blinking, use short presses (<2 sec)
of the Configure button to cycle through the various
monitoring options.
3. The function chosen will be displayed on the LED array for
each port.
The chart on the following page details the functions indicated
by the LEDs while in a lit (green) condition.
4-19
CONFIGURATION AND MANAGEMENT