Filter
Top Products
2
2-6
Hand-held Monitor User’s Guide – June 1994
GFK-0121E
Permanent Installation
If the Hand-held Monitor is to be installed using the metal bracket provided, follow the
instructions below. Do not install the HHM yet if it will be used to configure I/O blocks.
The mounting bracket provided can be used to install the Hand-held Monitor behind a
panel. You will need to make a cutout in the panel for the HHM (see next page).
You will also need to install a connector for the Hand-held Monitor within reach of the
HHM’s cable. The extra D-shell connector provided with the Hand-held Monitor
requires a panel cutout, with the bus cable and Hand-held Monitor located on the
opposite sides of the panel (see page 2-8).
An optional panel-mountable or DIN rail-mountable connector is also available. It does
not require a cutout. See page 2-9 for details.
Behind PanelBack of HHM
Bracket
Optional HHM
Connector
To Power Source
Bus In
Bus Out
Configuring a Permanently-installed HHM
Ordinarily, a Hand-held Monitor installed on a panel serves as an operator station. Its
configuration may be different from that of a portable HHM.
Its Device Number must be changed from 0 to some other number.
Automatic shutoff may be disabled.
I/O block configuration and other features may also be disabled.
After the HHM is configured, its keyswitch should be placed in MON position, and the
key removed.