Filter
Top Products
3
3-5
GFK-0121E
Chapter 3 Getting Started
Changing the HHM Display Language
The next display shows the current language
selection.
HHM CONFIG
LANGUAGE
ENGLISH
tgl entr nxt
Press F2 (TGL) to change the display language
(French, German, Italian, English). Press F3
(Enter) to save the change.
Selecting the Host CPU
The next display shows the Hand-held Monitor’s
host CPU selection. The choices are: Series Six,
Series Five, PCIM/QBIM/GENI, or Series 90.
SELECT HOST CPU
SERIES SIX
To change the host CPU type, press the F2 (TGL)
key, then press F3 (Enter).
Enabling/Disabling Automatic Shutoff
The next screen shows whether automatic shutoff
is selected.
AUTO OFF = 1Omin
ENABLED
This feature conserves battery power by shutting
off the Hand-held Monitor 10 minutes after the
last key press. To change the current selection,
press F2 (Toggle), then F3 (Enter).
Enabling/Disabling the Ability to Change Block
ID Parameters
The next display shows whether the Hand-held
Monitor is able to configure the Block Number
(serial bus address) of bus devices, as well as the
I/O circuit mix of some types of I/O blocks.
CHNG BLK ID
ENABLED
This selection also determines whether the HHM
is able to assign the Reference Address of I/O
blocks, or change the I/O mapping of a Remote
I/O Scanner (for the modules in its remote drop).
To enable or disable this capability, press F2 (TLG),
then F3 (Enter).