Filter
Top Products
4
4-3
GFK-0121E
Chapter 4 Device Configuration: Overview
Displaying the Configuration Menus
The illustration below shows how to reach the
HHM’s device configuration menus from the Main
Menu.
For all devices, you will need to select F3 (Con-
figuration) then F1 (Program Block ID) to con-
figure a block’s required features.
Device Number (serial bus address).
I/O type for input/output blocks.
CPU references.
Baud rate.
For new blocks, this must be done first.
To configure Genius blocks, select F3 (Configu-
ration) from the Main Menu, then F2 (Config-
ure Block) to view and modify other features.
Detailed configuration instructions for each
type of device are provided in its User’s Manual.
You can use F3 (Copy Configuration) to copy a
configuration from one block on the same bus
to another.
To configure a remote drop, continue from the
Program Block ID screens to enter the remote
map (I/O References) and Drop ID. Then go to
the Configure Block screens to configure re-
dundancy and Configuration Protection.
For a Field Control device, select either F2
(Analyze) or F3 (Configuration) from the Main
Menu. The HHM will then display a special set
of screens for Field Control. (The currently-ac-
tive device must be the Field Control device for
these screens to appear. See page 4-7 if you
need instructions to select the active device).
If the message E: CONFIG PROTECT appears,
you can remove Configuration Protection by:
1. Going through the configuration screens to
reach the Configuration Protection screen.
2. Pressing F2 (Toggle) to select either DISABLED
or ENABLED.
3. Pressing F3 (Enter) to save the selection.
4. Pressing F4 (Next) to go to the first configura-
tion display, D MENU to return to the Configu-
ration menu, or HOME to return to the Home
menu.
Genius Blocks
and Remote I/O Scanner
Configure an
I/O Block
F1
F2
F3
F 1 : H H M U T I L I T I E S
F 2 : A N A L Y Z E
F 4 : D E V I C E M E M O R Y
F 3 : C O N F I G U R A T I O N
F 1 : P R O G B L O C K I D
F 2 : C O N F I G B L O C K
F 3 : C O P Y C O N F I G
F 4 :
P R O G B L O C K I D
I / O (device references)
B L O C K N O . (device)
r e f b l k n x t
C O P Y C O N F I G
F R O M : n T O :
c h n g e n t r
F 1 : M o n i t o r
F 2 : C o n f i g u r a t i o n
Field Control
Devices
F 1 : G E N I U S C O N F I G
F 2 : M o d u l e C o n f i g
F 3 : P r e v i o u s M e n u
All Devices
F3
F2 or F3
Remote I/O Scanner
Configure a Remote
Map
Displaying the HHM
Configuration Menus