Filter
Top Products
22
Chapter 2 Installation
Connecting SCSI Peripheral Devices
SCSI peripheral devices can be connected to the SCSI connectors of the AIT
autoloader. The SCSI configuration of the autoloader is as shown below.
Connect the devices according to the system environment.
Notes
• The default factory settings of the SCSI IDs are as follows.
-AIT drive: 0
-Loader: 1
• Do not use repetitive SCSI IDs.
• Connect peripheral devices before turning on the AIT autoloader and host
computer.
Turning the Power On/Off
Turn On the Power
Turn on the AIT autoloader, then turn on the host computer.
1
Press the power switch on the rear of the autoloader, as illustrated.
Loader controller
SCSI ID : 1
SCSI connectors
AIT drive
SCSI ID : 0