Sony C9000 Printer User Manual


 
41388601TH Rev.2 109 /
2-2 Paper Input Jam (Multipurpose Tray (MT))
Does the paper jam occur immediately after the printer is powered on?
Yes Is the paper jammed at the entrance cassette sensor or the entrance MT sensor ?
Yes Remove the paper jam.
No Does the lever of the entrance MT sensor operate normally?
No Replace the defective sensor lever.
Yes Does the entrance MT sensor work properly?
(Operate the sensor lever and confirm that the sensor works properly with the signal on the
FSENS connector pin on the engine board (K73 PWB).)
Pin 2: Entrance MT sensor
No Check the connection of the signal cable, or replace the sensor board (R71 PWB).
Yes Check the signal cable connection, or replace the engine board.
No Does the paper jam occur immediately after paper is fed?
Yes Does the paper reach the entrance MT sensor ?
Yes Go to .
No Replace the multipurpose tray assembly.
No Does the registration motor rotate properly?
No Is +32V supplied to the POWER connector Pins 7~10 on the engine board?
No Replace the low-voltage power supply unit.
Yes Check the connection of cables, or replace the engine board.
Yes Go to 2-3 Paper Feed Jam.
A
A