Filter
Top Products
9(GB)
Starting the DASK-S704 Using the “GoToSample” Function of the
Sampling Reverb Software
When you use the DRE-S777 or DASK-S701/S702/S703 sampling reverb
software (Version 2.0) CD-ROM, you can start the DASK-S704 from
“GoToSample” on the SETUP display of the sampling reverb software.
1 Highlight “GoToSample” on the SETUP display of the sampling
reverb software.
SETUP display of the DRE-S777 or DASK-S701/S702/S703
SETUP
GoToSample :
Licence :
PreDelay : ms
Serial Sel : RS232C [ 9600]
Service :
Enter
2 Press the F4 key.
“Go To Sampling CDROM?” is displayed in a pop-up window.
3 Press the F4 key.
“Please change DASK-S704 CDROM and MS” is displayed.
4 Change the Memory Stick and CD-ROM to those supplied with the
DASK-S704.
To insert/remove the CD-ROM and Memory Stick, see “Starting the DASK-
S704 by Turning on the Power of the DRE-S777” on page 7.
5 Press the F4 key.
The DASK-S704 Sampling Function Software is loaded from the CD-
ROM. The loading is complete within about 3 minutes. After loading,
the DASK-S704 initial display appears.
SAMPLE Enter
Rehearsal
Sampling
Compile
Change MS
MS:xxxxxxxx 24MB Available
Fs/Period=Fs/5.5sec
Repeat =16
Input =AD
Clock =Internal 48.0 kHz
Notes
• When a Memory Stick is changed, “Please insert MS” message may
appear if the DRE-S777 cannot recognize the Memory Stick. In this
case, press the F4 key again.
• If you insert a Memory Stick which is not the DASK-S704 Memory
Stick, “Licence code error Please change Licence MS” is displayed.
Change to the DASK-S704 Memory Stick, then press the F4 key.