Filter
Top Products
19(GB)
6 Press the F4 key, and select the type of data using the jog dial.
You can select Fs, 2Fs or 2Fs & Fs when you have sampled with 2Fs/
5.5sec. (Skip this step when you have sampled with Fs/5.5sec or Fs/
11sec. Proceed to step 7.)
NoSAMPLE
Rehearsal
Sampling
Compile
Change MS
Please Select Output File
Fs
2Fs
2Fs & Fs
Exit Enter
7 Press the F4 key.
Compiling is performed.
“Loading CDROM/MS” is displayed, then “Compiling Fs (or 2Fs)
data. Please wait for a few minutes.” appears. It takes several minutes
to compile.
EnterNoSAMPLE
Rehearsal
Sampling
Compile
Change MS
Compiling Fs data.
Please wait for
a few minutes.
Exit
When compiling is finished, “Loading CDROM/MS” is displayed,
then the following display appears.
SAMPLE
Rehearsal
Sampling
Compile
Change MS
Detected direct sound are
L=[ 10.00m] R=[ 10.00m]
Apply these values?
Exit EnterNo
L=[xxx.xx m] and R=[xxx.xx m] show the distance between the direct
sound source (speakers) and the left and right microphones while
sampling. Using these values as reference, judge if the sound data
prior to the direct sound should be deleted or not.
8 To delete the data prior to the direct sound, press the F4 key
To retain the whole sampled data without deleting, press the F2 key
(No).
Tips for judgement
• For the plate reverb, do not delete the data prior to the direct sound.
• When value L greatly differs from value R even though the speaker
was located in the center of the stereo microphones while sampling,
the direct sound could not be detected due to background noise. In
this case, first compile the sampled data in two ways: deleting the
data prior to the direct sound, and not deleting the data, check both
impulse responses in step 10, then keep the one with the clearer
impulse position as the reverb program.
(continued)