Filter
Top Products
1-6
SRX-T420
M8
bolts
Jack
Jack
M8 bolts
Holes
Adjuster pipe
assembly
Adjuster pipe
assembly
Jack
Frame
n
When setting the jack, pay attention to
the holes on the bottom of flame.
Fig. 1-2b
In the case of tilt angle from 5 to 10 degrees:
1. Remove the panel (U7) block assembly. (Refer to Section 1-1-2.)
2. Remove the panel (U2) block assembly. (Refer to Section 1-1-3.)
3. Remove the panel (U3). (Refer to Section 1-1-4.)
4. Remove the panel (U6). (Refer to Section 1-1-5.)
5. Remove the panel (U5). (Refer to Section 1-1-6.)
6. Set the tools such as jack at both sides of frame, then
raise the rear portion of the main unit.
7. Remove the four M8 bolts.
8. Move the adjuster pipe assembly downward and insert
the four M8 bolts into the four holes to secure it.
9. Lower the jack and attach the panel (U5), panel (U6),
panel (U3), panel (U2) block assembly and panel (U7)
block assembly.