Filter
Top Products
2-10
SRX-T420
Fig. 2-2-6
2-2-6. SNMP
SNMP (Simple Network Management Protocol) is set.
SNMP
sysName: Type the character string of standard MIB sysName.
Contact: Type the character string of standard MIB sysContact.
Location: Type the character string of standard MIB sysDescr.
Send authentication trap: Place a check mark when accepting the sending of authentication trap.
Accept SNMP packets from any host: Select this when accepting the access from any host.
Accept SNMP packets from these hosts: Select this when accepting the access only from the specifi ed
host.
(Address): Type the IP address of the host that you accept the access.
[>>] button: Add the typed IP address of the host to the list.
[<<] button: Delete the typed IP address of the host from the list.
(Registration list): Registration list of the IP address of the host that you accept the access.
Community: Edit and select the community name.
. [Add] button: Add the community name.
. [Edit] button: Allow the selected community to enter the attribute edit mode.
. [Remove] button: Delete the selected community.
Community name: When the [Edit] button is clicked, the community whose attribute is changed
appears and the following items are enabled.
Rights: Select the access authority.
[Set|to|List]
button: Attribute change is applied.
[Cancel]
button: Attribute change is cancelled.
Trap Destinations: Type the IP address of the host of the trap destination.
[>>] button: Add the typed IP address of the host to the list.
[<<] button: Delete the typed IP address of the host from the list.
(Registration list): Registration list of the IP address of the host of the trap destination.