Filter
Top Products
2-4
SRX-T420
2-1-2. Function Memory
You can register the settings that have been adjusted in the control windows to FUNCTION 1 to 7. As the
default setting, the settings are registered to FUNCTION 1. To register the settings to FUNCTION 2 to 7,
click one of the FUNCTION 2 to 7 radio buttons, then adjust the items in each window.
You can recall the desired setting by clicking one of the FUNCTION radio buttons.
n
When you click the FUNCTION button to switch to another FUNCTION setting, the picture will be cut
off for up to about 10 seconds. The picture with the selected FUNCTION setting will then appear on the
screen.
2-1-3. Log Function
If you select File → Save Log on the menu bar of the control window, the communication log between
SRX controller and this unit (from the startup of SRX Controller to that point of time) can be stored up to
5 MB.
2-2. Setting of Projector
The status of this unit is set.
Operation procedure
1. Start SRX Controller and open the SETTING window. (Refer to Section 2-1-1.)
2. Click the setting item on the left side of the SETTING window to display the item that you want to
set.
3. After setting the items, click the [APPLY] button in the lower area of the window.
The setting is registered.
Setting items
Fig. 2-2