Filter
Top Products
1-1
SRX-T420
Section 1
Installation
Panel (U8)
Front side
Rear side
Panel (U7) block assembly
Panel (U2) block assembly
Panel (U4) block assembly (420)
Panel (U3)
Panel (U1)
Panel (U1B)
Panel (U6)
Panel (U5)
Panel (U4B) (420)
Fig. 1-1-1
Outline
The light source lamp bulb and projection lens are optionally available. You can incorporate them in the
system as required. For selecting the light source lamp and projection lens, contact your local Sony Sales
Offi ce/Service Center.
Before turning on the power of the main unit, perform the following procedure as required. (For details,
refer to the description of each section.)
For the removal of the cabinet panel required for each procedure, refer to Section 1-1.
m
. It is not required to perform steps 1 to 8 sequentially. However, do not perform the connection of power
cord in step 9 before completing steps 1 to 8.
. Be sure to remove the lamp bulb when moving this unit.
1. Adjust the tilt angle. (Refer to Section 1-2.)
2. Install the duct. (Refer to Section 1-3.)
3. Install the projection lens. (Refer to Section 1-4.)
4. Install the lens cover. (Refer to Section 1-5.)
5. Install the lamp bulb. (Refer to Section 1-6.)
6. Install the optional board to INPUT A and INPUT B slot. (Refer to Section 1-7.)
7. Connect the interlock connector. (Refer to Section 1-8.)
8. Connect and wire the external device. (Refer to Section 1-9.)
9. Connect the power cord. (Refer to Section 1-10.)
1-1. Removing/Installing the Cabinet Panel
n
The four (each two) keys of the panel (U7) block assembly and panel (U4) block assembly (420) described
in this section are supplied with this unit.
1-1-1. Name of Cabinet Panel