Filter
Top Products
Owner’s Manual Rev 1.0 Page 120 of 120
Integer type Parameter which specifies a particular PDP context
definition (see +CGDCONT command). If no <cid> is
specified, the addresses for all defined contexts are
returned
<PDP_address> Description
String type A string that identifies the MS in the address space
applicable to the PDP. The address may be static or
dynamic. For a static address, it will be the one set by
the +CGDCONT command when the context was
defined. For a dynamic address it will be the one
assigned during the last PDP context activation that
used the context definition referred to by <cid>.
<PDP_address> is omitted if none is available
6.7 AT+CGQMIN Quality of Service Profile (Minimum
Acceptable)
Description Command Possible Responses
Set minimum
acceptable
profile
+CGQMIN=[<cid>
[,<precedence>
[,<delay> [,<reliability>
[,<peak>
[,<mean>]]]]]]
•_ +CME ERROR: <err>
•_ OK
•_ ERROR
Read the
command
+CGQMIN?
•_ +CGQMIN: <cid>,
<precedence>, <delay>,
<reliability>, <peak>,
<mean>[<CR><LF>+CGQMIN
: <cid>, <precedence>,
<delay>, <reliability>,
<peak>, <mean>[…]]
•_ OK
•_ ERROR
Test if the
command is
supported
+CGQMIN=?
•_ +CGQMIN: <PDP_type>, (list
of supported <precedence>s),
(list of supported <delay>s),
(list of supported
<reliability>s) , (list of
supported <peak>s), (list of
supported
<mean>s)[<CR><LF>+CGQM
IN: <PDP_type>, (list of
supported <precedence>s),
(list of supported <delay>s),
(list of supported
<reliability>s) , (list of
supported <peak>s), (list of
supported <mean>s)[…]]