Filter
Top Products
Owner’s Manual Rev 1.0 Page 150 of 150
1 Enables reporting of local port rate (+ILRR: is
transmitted)
10.14 AT+IPR Cable Interface Port Command
Description Command Possible Responses
Defines fixed DTE rate AT+IPR=[rate]
•_ OK
•_ ERROR
Read the current setting
AT+IPR?
•_ +IPR:<rate>
•_ OK
•_ ERROR
Show if the command is
supported
AT+IPR=?
•_ +IPR: (), (list of
fixed-only <rate>s)]
•_ OK
•_ ERROR
Specifies the data rate at which the DCE will accept commands, in addition to
1200 bits/s or 9600 bits/s (as required in v25ter, subclause 4.3). It may be
used to select operation at rates used by the DTE, which the DCE is not
capable of automatically detecting.
The specified rate takes effect following the issuance of any result code(s)
associated with the current command line.
<rate> Description
Discrete integer
value
The <rate> value specified shall be the rate in bits per
second at which the DTE-DCE interface should operate,
e.g. “19 200” or “115 200”. The rates supported by a
particular DCE are manufacturer specific.
The following rates, are supported;
1 200
2 400
4 800
9 600
19 200
38 400
57 600
115 200
230 400
460 800