Filter
Top Products
Owner’s Manual Rev 1.0 Page 65 of 65
If the dial string is omitted, and the semicolon included, the command
instructs the ME to do a network detect. If the network is available OK is
returned.
Abortability:
Aborting an ATD command is accomplished by the transmission from the DTE
to the DCE of any character. A single character shall be sufficient to abort the
command in progress; however, characters transmitted during the first 125
milliseconds after transmission of the termination character are ignored. This
is to allow the DTE to append additional control characters such as line feed
after the command line termination character.
<dial_string> Description
“
0 1 2 3 4 5 6 7
8 9 * # +”
Valid characters for origination
W The W modifier is ignored but is included only for
compatibility purposes
, The comma modifier is ignored but is included only for
compatibility purposes
T The T modifier is ignored but is included only for
compatibility purposes
P The P modifier is ignored but is included only for
compatibility purposes
<Final Result
Code>
Description
CONNECT If connection is successfully established, only valid for
data connections
CONNECT
<text>
If connection is successfully established, only valid for
data connections
NO CARRIER Unable to establish a connection or the connection
attempt was aborted by the user
ERROR An unexpected error occurred while trying to establish
the connection
NO DIALTONE The mobile phone is being used for a voice call or is not
within coverage of the network
BUSY The phone number called is engaged, valid for data and
voice connections
OK Only valid for voice connections
<text> Description
19200 Connected with data bit rate of 19200 bits/s (HSCSD)