Filter
Top Products
ADJUSTING THE PRINTING GAP
The distance between the print head and the platen can be adjusted to
accommodate different paper thicknesses. To make this adjustment, remove
the top cover. The adjustment lever is located near the left end of the paper
bail. Pulling the adjustment lever towards you widens the gap; pushing it
away from you narrows the gap.
There are four positions; you can feel the lever clicking into each position.
The first position (narrowest gap) is the one most commonly used for single
sheets of paper. Try different positions until you get the best printing results.
Adjustment lever
Figure 7-74. Adjusting for different thicknesses of paper
DIP SWITCH SETTINGS
When you remove the printer’s cover and look inside, you will see on
the green board at the bottom of the printer two groups of small switches
marked DSWl and DSW2. These are the printer’s DIP (Dual In-line
Package) switches. DSWl has eight switches, named l-l to 1-8 from left
to right. DSW2 has four switches named 2-l to 2-4.
For all switches, the ON position is towards the back of the printer and
the OFF position is towards the front. To set a DIP switch, use a ballpoint
pen or other small implement to move the switch to the ON or OFF position.
The printer’s power should be off when you set the DIP switches. Settings
made while power is on do not take effect until power is switched off, then
on again, because the printer reads the DIP switches only at power-up.
-
14