Filter
Top Products
7.
Place the new print head on its support, seating it on the two pins.
8.
Thread the new cable the same way as the old, securing it under the
tabs on the print head carriage.
9.
Plug the cable into the connector, inserting it as far as it will go.
L
Fl
Connector cover
I
igure 5-2. Replacing the print head
10. Fasten the print head down with the two screws.
11. Move the carriage back toward the right and replace the connector cover.
Slide the connector cover to the left until it locks into place.
12. Replace the ribbon cartridge and top cover, and plug the power cord
back in.
47