Filter
Top Products
This is what you will get:
This line s-pacing is cet to 11
This line spacing is set to 12
This line
c.pacirig i 5. set to 14
This line spacing is set to 15
This line spacing is set to 10
This line spacing is set to 17
Thir 1 ine
spacing is set to 18
This 1 lne %z.pacing is set to 19
Thic line spacing is set ta 20
This line spacing is set to 21
This line
spacing is E.et to 22
This line spacing is set to 23
This line spacing is ~-et to 24
This line spacing it. set to 25
Line
cpacing i E set to l/t, i rich
inomal 1) .
.-.
When you run this program with IBM mode, you cannot get
the printout as shown above.
The command < ESC> “A” CHR$(n) in IBM mode only
defines the line spacing as n/72 of an inch; the < ESC > “2”
command changes the line spacing to the amount defind by the
previous < ESC > “A”.
So, you need to change the following lines to the previous
program as shown below for the IBM mode:
30 LPRINT CHR$ (27) “A” CHR$ (I) ; : LPRINT CHR$( 27)
II 11.
2 ,
79 LPRINT CHR$( 27) “A” CHR$ (12) ; : LPRINT CHR$( 27)
If 11
2
51