Filter
Top Products
Chapter 1 Introduction 11
Assigning Static SP Network Settings
Follow these steps to set the SP network settings using a static IP address. You must
specify a subnet mask and default gateway. This example uses the following sample
settings:
IP Address: 192.168.1.2
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.254
1. Press any operator panel button on the server front panel (see
FIGURE 1-4).
The LCD panel displays the first menu option:
Menu:
Server Menu
2. Press the Forward operator panel button until you reach the SP menu:
Menu:
SP menu
3. Press the Select operator panel button to display the SP menu options.
SP Menu:
Set SP IP info?
4. Press the Select operator panel button. The following prompt displays with the
default response:
SP use DHCP?
No
5. Press the Select operator panel button.
The LCD displays as follows:
SP IP Address:
0.0.0.0
6. With the cursor in the first field, increase or decrease the value using the Back and
Forward operator panel buttons.
This field can hold a value between 0 and 255.
SP IP Address:
10.0.0.0
7. After reaching your desired value, press the Select operator panel button to
advance the cursor to the next field.
SP IP Address:
10.
0.0.0