Filter
Top Products
Telect, Inc. • USA +1.509.926.6000 • Mexico +1.52.33.3836.3700
Poland +1.48.713.239.100 • UK +1.44.1489.889500 • www.telect.com
Copyright © 2002 Telect, Inc., All Rights Reserved
Page 2-12
1. Remove blank faceplate at intended breaker position.
2. Before installing a breaker, screw face plate to breaker, as shown in the following illustration.
NOTE
Breakers are installed in the panel so that the OFF position is toward the outboard side of the panel. In other words, install
breakers so that the LOAD side is toward the outside edge of the panel; that is, LOAD should be on the right on Side B, as
shown below, and on the left on Side A.
3. Make sure breaker is off and then install firmly in panel. Use screw to secure breaker to panel.
4. Label output on designation label next to circuit breaker.
5. Proceed to test the BDFB / BDCBB, as outlined in the next section, Output Testing, before turning on circuit breakers for the first
time.
Telect breaker face plate
Circuit breaker
OFF is on the right for
Side B, as shown here.
(OFF is on the left for Side A.)