Filter
Top Products
e-STUDIO281c/351c/451c ERROR CODE AND SELF-DIAGNOSTIC MODE© June 2005 TOSHIBA TEC
2 - 10
CBC0Finisher related
service call
Alignment motor abnormality: Alignment motor is
not rotating or aligning plate is not moving normally.
[MJ-1024]
P. 5-72
CBD0Guide motor abnormality: Guide motor is not rotat-
ing or guide is not moving normally. [MJ-1024]
P. 5-73
CBE0Paper folding motor abnormality: Paper folding
motor or paper folding roller is not rotating normally.
[MJ-1024]
P. 5-73
CBF0Paper positioning plate motor abnormality: Paper
positioning plate motor is not rotating or paper posi-
tioning plate is not moving normally. [MJ-1024]
P. 5-73
CC00Sensor connector abnormality: Connector of guide
home position sensor, paper pushing plate home
position sensor or paper pushing plate top position
sensor is disconnected. [MJ-1024]
P. 5-74
CC10Micro switch abnormality: With all covers closed,
inlet door switch, delivery door switch or front cover
switch is open. [MJ-1024]
P. 5-74
CC20Communication error between finisher and saddle
stitcher: Communication error between finisher con-
troller PC board and saddle stitcher controller board
[MJ-1023/1024]
P. 5-74
CC30Stack processing motor abnormality: The stack pro-
cessing motor is not rotating or the stack delivery
belt is not moving normally. [MJ-1022]
P. 5-75
Stack transport motor abnormality: The stack trans-
port motor is not rotating or the stack transport belt
is not moving normally. [MJ-1101]
P. 5-76
CC31Transport motor abnormality: The transport motor is
not rotating or the stack transport roller -1 and -2 is
not rotating normally. [MJ-1101]
P. 5-76
CC40Swing motor abnormality: Swing motor is not rotat-
ing or swing unit is not moving normally. [MJ-1023/
1024]
P. 5-76
CC41Paper holder cam home position abnormality: The
paper holder cam is not at the home position. [MJ-
1101]
P. 5-77
CC50Horizontal registration motor abnormality: Horizon-
tal registration motor is not rotating or puncher is
not shifting normally. [MJ-1023/1024 (when MJ-
6004 is installed)]
P. 5-77
CC51Sideways adjustment motor (M2) abnormality:
Sideways adjustment motor is not rotating or
puncher is not shifting normally. [MJ-1101 (when
MJ-6101 is installed)
P. 5-77
CC52Skew adjustment motor (M1) abnormality: Skew
adjustment motor is not rotating or puncher is not
shifting normally. [MJ-1101 (when MJ-6101 is
installed)]
P. 5-78
CC60Punch motor abnormality: Punch motor is not rotat-
ing or puncher is not shifting normally. [MJ-1023/
1024 (when MJ-6004 is installed)]
P. 5-78
CC61Punch motor (M3) home position detection error:
Punch motor is not rotating or puncher is not shift-
ing normally. [MJ-1101 (when MJ-6101 is installed)]
P. 5-79
Error codeClassificationContentsTroubleshooting
06/08