Filter
Top Products
© June 2005 TOSHIBA TECe-STUDIO281c/351c/451c ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 11
2
CC71Finisher related
service call
Punch ROM checksum error: Abnormality of check-
sum value on Hole punch controller PC board is
detected when the power is turned on. [MJ-1101
(when MJ-6101 is installed)]
P. 5-79
CC72Punch RAM read/write error: Abnormality of check-
sum value on Hole punch controller PC board is
detected when the power is turned on. [MJ-1101
(when MJ-6101 is installed)]
P. 5-79
CC80Front alignment motor abnormality: Front alignment
motor is not rotating or front aligning plate is not
moving normally. [MJ-1022]
Front aligning plate motor abnormality: Front align-
ing plate motor is not rotating or aligning plate is not
moving normally. [MJ-1023/1024]
P. 5-80
Rear alignment motor abnormality: The rear align-
ment motor is not rotating or the rear alignment
plate is not moving normally. [MJ-1101]
P. 5-80
CC90Upper stack tray lift motor abnormality: The upper
stack tray lift motor is not rotating or the upper stack
tray is not moving normally. [MJ-1022]
P. 5-81
CCA0Lower stack tray lift motor abnormality: The lower
stack tray lift motor is not rotating or the lower stack
tray is not moving normally. [MJ-1022]
P. 5-82
CCB0Rear jogging motor abnormality: The rear jogging
motor is not rotating or the rear jogging plate is not
moving normally. [MJ-1022]
P. 5-82
CCD0Stack ejection motor abnormality: Stack ejection
motor or stack ejection roller is not rotating nor-
mally. [MJ-1023/1024]
P. 5-83
CCE0Paper trailing edge assist motor abnormality: Paper
trailing edge assist motor is not rotating or paper
trailing edge assist is not moving normally. [MJ-
1023/1024]
P. 5-83
CCF0Gear changing motor abnormality: Gear changing
motor is not rotating normally. [MJ-1023/1024]
P. 5-83
CDE0Paddle motor abnormality: The paddle motor is not
rotating or the paddle is not rotating normally. [MJ-
1101]
P. 5-84
CE00Communication error between finisher and punch
unit: Communication error between finisher control-
ler PC board and punch controller PC board [MJ-
1023/1024 (when MJ-6004 is installed)]
[MJ-1101 (when MJ-6101 is installed)]
P. 5-84
CE10Image control related
service call
Image quality sensor abnormality (OFF level): The
output value of this sensor is out of a specified
range when sensor light source is OFF.
P. 5-85
CE20Image quality sensor abnormality (no pattern level):
The output value of this sensor is out of a specified
range when the image quality control test pattern is
not formed.
P. 5-86
CE40Image quality control test pattern abnormality: The
test pattern is not formed normally.
P. 5-87
CE50Temperature/humidity sensor abnormality: The out-
put value of this sensor is out of a specified range.
P. 5-88
CE90Drum thermistor abnormality: The output value of
the drum thermistor is out of a specified range.
P. 5-88
Error codeClassificationContentsTroubleshooting
06/08