Filter
Top Products
67
Getting Started
Installing additional memory (optional)
5.375 x 8.375 ver 2.4.1
You will need a standard Phillips No.1 screwdriver and a
small flat-head screwdriver to install a memory module.
To avoid damaging the computer’s screws, use a standard
Phillips screwdriver that is in good condition.
1 If the computer is on, turn it off.
See “Turn Off or Shut down command” on page 103.
2 Unplug and remove any cables connected to the
computer.
3 Open the display panel and remove the panel above the
keyboard that contains the power button.
When removing the computer’s power button panel to install
additional memory, be careful not to damage the display or
circuit board.
Using a flat-head screwdriver to pry off the panel
You can pry the panel out of its position by using a flat-
head screwdriver. Starting at the left or right side,
carefully wedge the flat-head screwdriver between the