Filter
Top Products
INITIAL SETTINGS
2-7
Setting the Date and Time
Fax Setup
The date and time that appear in the display are printed at the top of each page you
transmit. Set the date and time by pressing the keys on the operation panel as shown
below. To correct a mistake, press the STOP key to move the cursor back to the
mistake, and then enter the correct number.
Note: The unit supports millennial dates (those from the year 2000 on). To program
such a date, enter the last two digits; for example, the year 2000 is programmed
by entering “00”.
Use the following procedure to set the date and time:
Step Press these keys Comments
1 “ENTRY MODE” will appear in
the display.
2 “ENTER YEAR” will appear in
the display.
3 Enter the last two digits of the
year. “ENTER MONTH” will
appear in the display.
(example: 1999)
4 Enter the month (2 digits: “01”
for January, “02 for February,
“12” for December, etc.).
“ENTER DATE” will appear in
the display.
(example: July)
5 Enter the day of the month (“01”
to “31”). “PRESS ENTER KEY”
will appear in the display.
(example: the fifth)
6 “ENTER TIME” will appear in
the display.
7 Enter the hour (2 digits: “00” to
“23”).
8 Enter the minute (2 digits: “00”
to “59”).
9 The clock starts when you
press this button. “STORED”
will appear in the display.
10 Press the STOP key twice to
exit.
DEF
ABC
ENTER
FUNCTION
DEF
JKL
ENTER
ABC
PQRS
WXYZ
WXYZ
STOPSTOP