Filter
Top Products
2. PRINTER SETUP
2- 4
Acceptable
operating
range
Recommended
operating range
10 20 30 40
20
40
60
80
%RH
°C
5 °C 90%
29 °C 90%
5 °C
55%
40 °C 39%
40 °C 10%
18 °C
60%
28 °C
60%
28 °C
40%
18 °C
40%
Front: 15 cm or over
Back: 5 cm or over
Right: 30 cm or over
Left: 10 cm or over
2.2 Installation Location
Install the printer in a place where ample space is reserved for operation. Also, place the printer on a
well ventilated, flat, level table or a rack specifically designed for the printer. Make sure that the 4 feet
of the printer make full contact with the surface of the desk or rack.
Ensure that there is sufficient space around the printer, as illustrated below.
CAUTION
Avoid locations that have the following adverse conditions. Failure to
do this may cause injuries or printer failure.
･ Direct sunlight
･ High temperatures and humidity or low temperatures and humidity
･ Rapid temperature changes
･ Direct cold air
･ Excessive vibration
･ Dust/Gas
･ Near magnetic or electromagnetic devices
･ Near open flames or wet locations
･ On an unstable desk or rack
Precautions
･ Ensure that an AC outlet is located near the installation location of the printer and that it allows for the
easy plugging and unplugging of the Power Cord. Do not place any obstacles around the AC outlet.
･ When the Peel-off Unit is used, the backing paper is ejected continuously from the lower section of the
Peel-off Unit. Particularly, when a label in use is long, choose an installation location carefully in
order to prevent it from sticking on a table or the ejected backing paper.